1Mere

1.1

The number of players shall be regulated by the regulation of thecompetition to publish FIFA.

1.2 1.2 1.2

One should be stamped in the center of the back and front (nonecessarily in the center) of all T-shirt and on the front of everythingused in uniform.

This art. 1 para. 2 would not apply to our mere prints on the front of theT-shirts used as a uniform in Club World Cup matchesFifa.

1.3 1.3 1.3

Meros (one or two days) should be single color or colorfulof the same chrome group; in this second case, it should be created, in view of theof FIFA, the single-color visual print and there should be a contrast oflight and dark colors between the strokes of the grouper and the uniform garment inNo. Based on the principle of contrast between light and dark colorsworn in uniform garments, and irrespective of circumstancessuch as meteorological conditions or amount of light, the color used

in our students appearing in uniform should be clearly readable
and distinguishable from afar for all players, colleagues, viewers
and, in addition, contrast with the colors used in the garmentof the uniform. Such contrast could be achieved with our userssingle color. Mero could be surrounded by an edge or shadingto improve its readability and make it possible to better distinguish it. The color of theT-shirts could be different from that of the countrymen.

1.4

An area of our group should be created on the back of the T-shirt unless,in the opinion of FIFA, the group is clearly readable and can distinguish itfrom a distance all players, colleagues, viewers and presscommunication and differentiate it from the colors of the equipment inirrespective of meteorological conditions and quantityof light. On the front of the T-shirt and the swimmer, an area ofMero.

Areas of our mere should be single-color to allow readabilityof our mere and, in them, decorative elements could not be placed. Stripesof a maximum of 2 mm wide in a different color would not be considered adisruption of the area.

The superfiI would like to see the back of the shirtoffibecause of the height and width of a group of two days. Topsvertical will be 2 cm above the highest point of the two days and
3 cm below the lowest point thereof. Your horizontal stopswould be 3 cm from the outer edge of the company on the left and 3 cm fromfrom the outer rim of the group on the right. If used, the superfiof the areaof our group on the front of the T-shirt or trouser should be proportionalto the company, leaving hisfispace to ensure visibilityof the world, irrespective of meteorological conditions or theamount of light.

1.5

Our groupers on the back of the T-shirts worn by players shouldbe between 25 and 35 cm high and should be focused on the back of theT-shirt.

On the back of the T-shirts worn by the players should bebe between 20 and 35 cm high and should be focused on the back of theT-shirt.

Our group should be completely visible when the T-shirt was insideof the shirt.

1.6

The width of the stroke of the back of player's t-shirtsmust be between 3 and 5 cm. Meros located on the front of the T-shirtshould be placed at chest height regardless of cut andsize. Our groupers on the front of the T-shirts should be between 10 and 15 cmof height.

1.7

Mero on the front of the swim could not be placed in any of thelegs. Our groupers on the front of the pantaloi should not be between 10 and 15 cmof height.

1.8

Meros of the T-shirts and pants of players of the sameshould not have the same size.

1.9

Mere appearing in the uniform should be sewn orfitoequipment using heat sealing or similar theory. Mere would befito the uniform permanently. Males could not be able tofiwithvelcro or otherwise provisional.

1.10

The shield orfiof the Member Association could only appear as a whole.at the bottom of each of the gytos on the back of theT-shirt. The next item is the next item orfiof the Member Associationwould be 5 cm2 and would not affect the readability of the group.
Except for the shield orfiof the Member Association, the Council cannot be found.contain, nor give the impression of contain, no identification whatsoeverfiScienceof the member, manufacturer, supplier or elements whichFIFA considers that they establish a communication with the Member Association, themanufacturer, supplier, sponsor or other third party.

1.11

Our T-shirts and pants could havefiventilationof a maximum of 2 mm wide. Only could be dividedin a maximum of four parts, by means of which will be widthMaximum 2 mm. Thefiventilation and divisions through

could not contain any kind of identificationfiof the manufacturer or thesupplier, commercial advertising, sponsors or products, messagesof any kind, decorative elements, design or other elements.